Use Of Battery

Use Of Battery

Date:Mar 16, 2021

1. Storage of batteries

(1) Storage of new batteries

For new batteries that have not been activated, the vent holes on the filling hole cover are all closed, do not break. Pay attention to the following points when storing the battery:

① Store at room temperature 5~30℃, dry, clean and ventilated.

②Do not expose to direct sunlight, and the distance from the heat source is not less than 2m.

③Avoid contact with any liquid and harmful gas.

④ Do not put upside down or lying down, do not stack, do not bear heavy pressure.

⑤ The storage time of a new battery shall not exceed 2 years.


(2) Storage of batteries that are not in use temporarily

The wet storage method is adopted, that is, fully charged first, then adjust the electrolyte density to 1.24~1.28g/cm3, adjust the liquid level to the specified height, and then seal the vent. The storage period should not exceed half a year. During the period, it should be checked regularly, such as capacity If it is reduced by 25%, it should be recharged immediately, and it should be fully charged before delivery.


(3) Storage of batteries that have been out of service for a long time

The dry storage method is adopted, that is, the fully charged battery is discharged at a discharge rate of 20 hours, then the electrolyte is poured out, and the water is repeatedly rinsed with distilled water until there is no acid in the water. The air vent is sealed and the storage conditions are the same as that of a new battery.


2. New battery activation

  First, wipe the outer surface, unscrew the filling hole cover, clear the vent hole, inject new electrolyte, let it stand for 4-6 hours, adjust the liquid level to the specified value, and charge it according to the initial charging specification before use.

  

The dry-charged battery can be directly added to the specified density of electrolyte during the specified storage period (usually 2 years) when it is started, and after standing for 20 to 30 minutes, the liquid level can be calibrated and it can be used. If part of the capacity is lost due to overdue storage or improper storage, it should be recharged after filling electrolyte.

be usable.


3. Disassembly and assembly of the battery

(1) When disassembling, assembling or moving the battery, handle it with care, and it is strictly forbidden to drag it on the ground.


(2) The battery model should be consistent with the vehicle model, and the electrolyte density and height should comply with the regulations.


(3) When installing, the battery is fixed on the bracket, and the anti-vibration pad is plugged.


(4) The pole piles are coated with mortar wood or lubricating oil to prevent corrosion and rust. The pole pile clamp should be in good contact with the pole pile.


(5) The ground polarity of the battery must be consistent with that of the generator.


(6) When wiring, connect the positive pole first and then the negative pole. When removing the wires, the opposite is true to prevent metal tools from grounding and short-circuit the battery.


Previous: Battery Maintenance

Next: Battery Type IntroductionBattery Type Introduction